Results 1 to 6 of 6

Thread: Between the coil abd cover...

  1. #1

    Between the coil abd cover...

    Boy I wish I took pics of the amount of dirt, sand, and tiny organic material (pine needles ect) that I found when I took off coil cover. Today I had to correct the washers on the NEL coil on the TR. It was too loose so the coil moved sometimes on its own. I decided to remove the coil cover when I heard a little rattle inside. Turns out there was a ridic amount of caked on debris. I didn't think stuff would get between there but apparently it does. So this serves as a heads up to check and clean yours every once in a while. I have two machines with coil covers, but no hours on one machine so it's not gonna have any yet.

  2. #2
    Elite Member Digger_O'Dell's Avatar
    Join Date
    Jun 2015
    Location
    near Milwaukee Wi.
    Posts
    3,937
    I've heard that excessive debris, especially if it's mineralized soil (rust, black sand, etc) it can really detract from the machine's performance, cause a lot of falsing and so on.
    Equipment:
    Minelab: CTX 3030, GPX 4800, X-Terra 705. Whites TDI SL.

    2024: Silver 1, Gold 0
    Best finds: 28 silver dime spill, 1800s Dutch customs seal.
    Oldest/best coins: Late 1700's Chinese Cash Coin, 1837 Upper Canada large cent, 1877 Seated Dime
    Oldest Relic find: 1800 Sailors Luck token
    You Tube: Rediscovering America
    Quote: Treasures are like potato chips, you can never have just one!

  3. #3
    I am sure there would be some mineralization everywhere so you would be bound to get a few grains in there every so often. So I was thinking it could possibly affect the readings just a tad, after it builds up over time. It's like carrying an extra 1mm worth of ground with you every where you swing.

  4. #4
    I take mine off all the time and clean them. Some guys use silicone around the edge of the coil cover to keep the dirt out. I never liked that solution since it would be a pain and messy if you ever needed to take the cover off.

  5. #5
    Global Moderator Fire Fighter 43's Avatar
    Join Date
    Mar 2010
    Location
    SE Wisconsin
    Posts
    3,962
    I clean mine about every 8 hours of detecting and more often if I was in sand or a really dirty area, muddy, no grass ext. I thought is it doesn't take long to do and if it improves performance even slightly it is worth doing.


    Minelab Equinox 800, 15”Coiltek, 11” & 6”coils

    XP Deus II , 11", 9” & 11x13 coils


    Detectors since 1977: Simplex, DEUS, CTX 3030, F75 Ltd, Etrac, Excal II, V3i, DFX, GTI2000, Eagle II, 6000DI, 6DB, AlaskanTR4B, Beachcomber

  6. #6
    I have sealed both my detectors coil covers with silicone. I have no worries about removing them for cleaning, and when the covers are in need of replacement, the silicone will not be that hard to remove, as it doesn't take much silicone to make the seal.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •