The Neils table is made for DFX. There is variation between the VDIs of DFX and VDIs of V3.
I have no penny of Lincoln for testing. Normalized 22.5kHz OFF, will give greater variation VDIs. Greater...
Type: Posts; User: Manuellar
The Neils table is made for DFX. There is variation between the VDIs of DFX and VDIs of V3.
I have no penny of Lincoln for testing. Normalized 22.5kHz OFF, will give greater variation VDIs. Greater...
To further differentiate between Zinc and Gold, you use 22.5kHz with Mormalized OFF. Expand the VDIs block and, at least, better identify zinc. Gold VDIs will always vary depending on their...
Thanks you.
I use translator from Spain.
regards ;)
Hello everyone.
I will try to explain how to configure and use my V3 (my land is very low mineral content).
1 .- At home set up:
I do not use discrimination, accept everything.
The VDIs I want...
Hi.
You can check your sweep speed indicated on this screen.
Set the mode V3 analize, leave a coin on the ground, go slow with the coil, (note that the curves are very broad and do not match the...
Hi, for those using the V3 and want MixMode in stereo:
Audio-Target Volume-Balance = -100
Audio-Audio Threshold-Balance = +100
Target Volume in the right channel sound. Audio Threshold and All...
Hi for all.
I have a question for CyberSage:
You are using the 10x12 SEF coil with good results. I have found that the SEF 10x12 (this SEF is from my previous DFX) that I use when I use only the...