Setting Rejected v3i tones to 0

[My4Kiwis]

Quick question...on the V3i is there an easy way to set rejected VDI's tone to zero in groups or do you have to do it one at a time?

Cheers,
JD

[CyberSage]

Yes, you can Change an entire range of tones easily. For example lets change the VDI range from (-94 to -1) to a tone setting of 0.

1. Within the VDI tone setting menu cursor to -94 with your up and down arrow buttons.

2. Use the right and left arrow buttons to set the desired tone. In this case 0

3. Hold down the Enter button.

4. Now while holding down the Enter button, press the up or down arrow button. This will set each VDI range to 0 as you pass over it. If you hold down the arrow button it will increase the rate of selection instead of just moving 1 VDI at a time. Let off the buttons when you reach the desired range. In our example this would be -1.

This is a great time saver.

Jack

[My4Kiwis]

Thanks for the quick response Jack! That info will be a huge help! I was just sitting here doing them one by one on this -18F morning...I am just back from overseas and am dying to get out and play with the things I'm learning.

Cheers,
JD

[CyberSage]

Your welcome JD. Good luck and welcome home!

Jack

[Lowjiber]

Welcome home! Thanks for your service. thumbsup01

[My4Kiwis]

Thanks guys, my contract ended and as of yesterday I am unemployed. I hope to be starting a new job in a month or so. In the meantime I'm going to trying to learn my machine. I did get out to a tot-lot on the AF Academy a couple of days ago and found a well worn 1944 Nickle. Not much but it fired me up.

Cheers,
JD

[Nitro 54]

Nothing wrong with finding a $1.75 melt value war nickle thumbsup01 8) 8)

[russellt]

jack is the man .... im learning alot from you guys .. oh and welcome home . ive been overseas myself and brother i dont care who you are . there is no place like home