Worked on getting the tumbler up and running since all the parts came in. After a quick paint job, casters attached, electrical and switch installed, and barrels wrapped in rubber strips for a clearance issue, I was ready to roll. It went fairly well, with a slight leak issue, because of a dirty seal...my fault. The only major problem I encountered was that the rubber strips would expand as the the unit was tumbling causing me to recut the ends so they would not buckle. Also, the glue I bought did not bond well between plastic (PE) and rubber. So, some snags left to fix, but it cleaned the first batch fairly well. This tumbler is big and has a good industrial feel to it. It needed it, cause each of the two 9 gallon barrels were 2/3 full of artifacts and water. They weighed a ton each lol. Here is the unit from purchase, to cleaned finds.