hey all, just wondering about v3 ground balance. When I gb. my v3 sometimes the threshhold does not change, what I mean is when I pump the detector on the ground the threshold is smooth before I start and stays smooth, it does not change. Is this normal? It seems to run fine. Any ideas on this? Thank you pointer80
" DIGGIN MICHIGAN"
It's normal in soil that is not mineralized. There is a starting point for GB embedded in the firmware. If the ground you're balancing is close, the initial adjustment won't be very much...if at all.
That's a good thing.
I've traveled a long way, and many of the roads weren't paved.
Thanks lowjiber, yes I'll take a good thing when I get it.
" DIGGIN MICHIGAN"
I wondered this myself. From time to time I get this exact behavior. Thanks John!
"Knowledge counts but common sense matters." ~ LouAnne Johnson
Minelab E-Trac - Whites Vision/V3 - JeTco GTX Huntmaster - Whites Bullseye TRX - Garrett Pro-Pointer
Posting Permissions
Reply With Quote