Hello everyone.
I will try to explain how to configure and use my V3 (my land is very low mineral content).
1 .- At home set up:
I do not use discrimination, accept everything.
The VDIs I want discriminate to give them sound ZERO (-94 to -31).
The rest (-30 to +95 and -95) use 16 blocks of sound...
Hi.
You can check your sweep speed indicated on this screen.
Set the mode V3 analize, leave a coin on the ground, go slow with the coil, (note that the curves are very broad and do not match the size of the coin). Go up speed scanning with the coil until the peaks are sharper and the indicated...
Hi, for those using the V3 and want MixMode in stereo:
Audio-Target Volume-Balance = -100
Audio-Audio Threshold-Balance = +100
Target Volume in the right channel sound. Audio Threshold and All Metal on the left channel sound.
This is the combination of tones that I use:
Audio-Tone-Tone ID...