Setting Rejected v3i tones to 0
- Thread starter My4Kiwis
- Start date
CyberSage
Moderator
Yes, you can Change an entire range of tones easily. For example lets change the VDI range from (-94 to -1) to a tone setting of 0.
1. Within the VDI tone setting menu cursor to -94 with your up and down arrow buttons.
2. Use the right and left arrow buttons to set the desired tone. In this case 0
3. Hold down the Enter button.
4. Now while holding down the Enter button, press the up or down arrow button. This will set each VDI range to 0 as you pass over it. If you hold down the arrow button it will increase the rate of selection instead of just moving 1 VDI at a time. Let off the buttons when you reach the desired range. In our example this would be -1.
This is a great time saver.
Jack
1. Within the VDI tone setting menu cursor to -94 with your up and down arrow buttons.
2. Use the right and left arrow buttons to set the desired tone. In this case 0
3. Hold down the Enter button.
4. Now while holding down the Enter button, press the up or down arrow button. This will set each VDI range to 0 as you pass over it. If you hold down the arrow button it will increase the rate of selection instead of just moving 1 VDI at a time. Let off the buttons when you reach the desired range. In our example this would be -1.
This is a great time saver.
Jack
Thanks guys, my contract ended and as of yesterday I am unemployed. I hope to be starting a new job in a month or so. In the meantime I'm going to trying to learn my machine. I did get out to a tot-lot on the AF Academy a couple of days ago and found a well worn 1944 Nickle. Not much but it fired me up.
Cheers,
JD
Cheers,
JD