Equinox 900 in Park 1: Recovery Speed 4 vs. 6 for coins next to iron

Harry Brenton

New member
Hi everyone, I’m Harry Brenton. I run a metal detector shop in the UK, and I’m interested in how Equinox 900 users set up for older parks where nails can mask a coin signal.


Here’s a simple comparison I’d like to hear your thoughts on. In Park 1 with the stock 11-inch coil, find a short, repeatable high tone next to an iron response. Before digging, sweep the same spot at Recovery Speed 4 and then 6. Keep sensitivity, Iron Bias, coil height, and sweep pace the same. Try both settings again from a quarter turn around the target.


I’d listen for whether the high tone is easier to hear separately from the iron and whether it repeats on the return sweep. Minelab’s manual describes the trade-off, a higher Recovery Speed can help separate close targets, but it can also reduce depth and make the target ID less reliable. Checking what actually comes out of the hole is what makes the comparison worthwhile.


If you’ve tried something similar in an iron-heavy park, did going from 4 to 6 help you hear coins you might otherwise have walked past, or did the weaker targets become harder to hear? If you remember the coil you used and what you dug, I’d be interested in those details.


Thanks,
 

Forum statistics

Threads
23,681
Messages
238,662
Members
3,854
Latest member
Harry Brenton
Back
Top