Etrac question on threshold

[Beavertail]

Has anyone notice during hunting the threshold getting quieter and a little higher pitched for a few seconds then going back to normal. I never noticed it till yesterday and was curious. I didn't know if it was auto groundbalancing or ???? Any feedback would be greatly appreciated.

 

[Full Metal Digger]

Quieter as in nulling? It should null out when passing over an iron target (assuming you are in coin mode). But that only lasts a millisecond or so. Maybe you are encountering buried power lines or mineralized ground?

 

[Beavertail]

Question on etrac threshold

No not nulling. It's like it gets quieter but a higher pitch threshold but it doesn't last long. It's definitely not buried power lines because I was in a very rural part of Alabama in a cattle pasture with nothing for miles. And on auto +3 sensitivity it's running around 25 so I don't think it's high mineralization. It's mostly sand.

 

[Beavertail]

And not on coin I was on a pretty much open screen looking for relics

 

[Digger_O'Dell]

Have you checked your audio response setting? Maybe you are set to the long or pitch hold, but it sounds like the long response setting to me.

 

[Beavertail]

No it's not long response I checked that. I don't know what it is I'll see if I can factory reset and see if that helps

 

[Digger_O'Dell]

Good luck, hope it takes care of the problem.