Going deep With The Vision/V3/V3i

[BHNugget]

Yes,with a coil other than the D2 this isnt noticed when in loctrac.With the 6x10 the offset definately has an effect.I tried the 6x10 for coinshooting and prospecting and could get a complete reversal with the offset adjustment (that is,going from an increase in threshold towards the ground, to an increase when lifting the coil away from the ground).I have noticed the difference in autotrac with the D2,as youve stated Jack.Its only the D2 in loctrac that the manual offset seems to have no effect on evening out the threshold.

 

[rcasio44]

The D2 is sensitive but is my favorite coil. The offset won't help. If you set to +1 and ground balance it will balance sightly positive. I won't help to make the coil balance. Rob

 

[DirtFisher]

Hi, Jack. I'm confused. If you aren't using discrimination how can you set your VDI tones so that you don't hear the VDI's you don't want to hear? VDI's aren't considered in All Metal mode. Thanks for the help.

 

[CyberSage]

Hi, Jack. I'm confused. If you aren't using discrimination how can you set your VDI tones so that you don't hear the VDI's you don't want to hear? VDI's aren't considered in All Metal mode. Thanks for the help.

I am in discrimination mode. I am just not setting any VDI's to be rejected. By setting the Tone to 0 you don't hear it.

 

[v3ikid]

This was a great post. Thanks

 

[DirtFisher]

Thanks, Jack. I understand now.

 

[kingskid]

How do I set up to get the 3 freq pinpoint with the single freq mode? Thanks for any assistance with this.

 

[CyberSage]

How do I set up to get the 3 freq pinpoint with the single freq mode? Thanks for any assistance with this.

Wouldn't this be a nice feature! Unfortunately this is not possible currently with the V3/V3i. The number of frequencies used for pinpoint mode will be the same as the number used in motion mode.

 

[Big Boys Hobbies]

Thank all. Great post!