Got a question about my E Trac

[Jack Flynn]

I changed coils and lower rod to a different set I received today. After unlatching the upper rod and sliding it off to unscrew the coil side of the pigtail I noticed that the pigtail attached to the control box had some play in it. Is it supposed to be tight held onto the box or have a little play? Just trying to make sure it doesn't have anything getting loose that could cause a problem later.

 

[Jason in Enid]

Mine has a little bit of play in it also. It doesn't look like it would affect anything, the rod latch is what holds the rod in place.

 

[OkieDigger]

That little bit of play is normal.

 

[Jack Flynn]

Thanks

 

[coinnut]

Mine has it too. I think you need it in order to pull out the rod while the coil is still attached. It has to come out some in order to disconnect the coil. If I am reading your question correctly?

 

[OkieDigger]

Coinnut, he's talking about the little dongle just under the control box. Where you attach the coil cable.

 

[coinnut]

Coinnut, he's talking about the little dongle just under the control box. Where you attach the coil cable.

The internal connector:huh: I never heard of the word dongle and neither has my Webster (dictionary), so I'm lost. :grin: If it's the connector, then Yes, slack is good, if it's the cam lock, then definitely NO. Mine is broken and the shaft is always sliding out. Thank God for duct tape

 

[OkieDigger]

Yep, the connector, aka dongle :grin: